Why Legionella Flushing of Taps & Showers is Important in Managing Legionnaires’ Disease

Legionella Flushing of Taps & ShowersIf you own or manage a building in the UK that has a water system of any kind, under current health and safety law you will need to identify the potential risks the system can cause from contamination by Legionella bacteria and the potential for Legionnaires’ disease.

The starting point in any safety evaluation of this kind should be a legionella risk assessment, although there are other things you can do to help minimise the risks, including regular flushing.

Legionella flushing of little used taps and showers

One key point to note is that legionella bacteria will multiply far more readily in stagnant water, i.e. water that is not moving. This is where flushing comes in. There may be parts of the water system that are not regularly used. For example, in a hotel during the off season, there could be rooms that are often empty. In this situation, a plan should be put in place to ensure these little-used taps, showers, other water outlets, and sections of the water system are thoroughly flushed through on a regular basis. This should be done at least once a week to ensure that stagnant water conditions are avoided and to minimise the possible build-up of bacteria.

Empty buildings can increase legionella risks

It is also worth noting that flushing might be required in circumstances where the usual risk of legionella is low. For instance, in a residential property that is rented out to tenants, there may be very little risk of the bacteria being able to spread. However, if that property is left without a tenant present for several weeks or months, the water in the system will not be flushed through because of a lack of use. In this case, the landlord should make sure that flushing takes place weekly to ensure the system is well-maintained and safe for the next tenant to use.

Legionella testing pre and post flush

Another point worth being aware of is the need to properly label all legionella water samples you take from any point of the water system you are responsible for. If legionella is present in the system (which it is more than likely to be, even at very low and manageable levels), it will often show at different concentrations depending on whether the sample was taken before (pre-flush) or after flushing (post-flush). So, whenever you take a sample, be sure it is labelled as such, so you know when it was taken and from where. Of course, the testing of water samples for legionella bacteria may not always be required; it will depend on the results of the risk assessment for each individual water system and a number of other site-specific risk factors that are outlined by the Health & Safety Executive in their legionella code of practice and guidance documents.

The benefits of regular flushing

Regular flushing of water outlets is therefore an important part of managing the legionella bacteria within a water system, and helping to keep it at safe levels. It may not always be needed, but when it is, it could make the difference between managing the bacteria levels or allowing them to multiply out of control and increasing the risk levels.

World-leading water safety specialists

Our teams of water safety specialists support those responsible for the control of legionella and other water safety issues across all regions of the UK and internationally, delivering professional water safety and legionella risk assessment solutions, water testing, independent compliance auditing, City & Guilds training and other environmental risk management services.

If you have questions about any of the issues raised above or you would like to speak with one of our specialists call us today on 0330 223 36 86 or get in touch here … contact us